Back to Florida

Our 9 days here in Georgia have flown by, always a good thing.  Have to admit I'm not too keen on going back, especially the procedure, but we are hoping it will solve my problem, fingers crossed.  But we are looking forward to trying out a new park that is actually closer to the hospital than our old park.

One of the first things we did once we arrived in Ellijay was to go have a delicious pizza and amazing burrata salad at Ellijay Wood Fired Pizza, exceptional!

As I mentioned we had a lot of appointments to go to while we were here, first on the list was getting Jan's hearing aids.  We had a big disappointment in Florida and so we had arranged it so we could go to a company here in Jasper that would be able to cut through the unbelievable red tape, order the hearing aids and get it all done before returning to Florida.  We showed up and Jan had to have another hearing test, NBD, then they started jumping through the insurance company's hoops.  2 hours later, which was making us very tight on our dentist appointments 50 miles away, we ordered and paid for hearing aids that were supposed to be delivered in under a week.  Then we ran south to our dentist, made it just in time, we both had our teeth cleaned and I had a permanent crown installed.  A long day to say the least.  One of our challenges while we are here in Ellijay is the distance to the doctor, dentist, friends, etc.  It is just a reality, a 120 mile round trip because we chose to stay in this very nice resort, Talona Ridge, due to the fact there are really no decent campgrounds closer, although we have our fingers crossed as a new one is being built much closer in.

The next day was dermatologist day, I got a 6 month reprieve, but Jan only got 3 months.  Then on to meet our good friends, John and Diane.  We had a great visit, went out for a nice lunch, came back for a cigar, and finally headed back north.

While here and between lunches we did a lot of exploring around the area.  Although we lived in the Kennesaw area for numerous years, we never took a hard look around the Canton/Woodstock area, and we really enjoyed what we saw, and the dynamite BBQ at Williamson Bros.

Delicious and plenty left for lunch the next day

A big item our list was to go see a gentleman and electronic wizard, Paul Whittle, from our Monaco Coach forum that has taken it upon himself to build and repair numerous electronics parts and pieces for our coaches that have been discontinued.  We have a multiplex system on our coach that controls lights, pumps, heating, awnings, shade, etc.  That way any switch anywhere can be programmed to turn any item on or off, but unfortunately the system in our coach has been discontinued.  We had one switch that was not working, in fact it would not turn off, and I had contacted Paul to see if he could fix it.  He lives close enough so that we could run down to his home where he promptly completed our repair and in fact installed 6 new switches in the panel.  Great experience and we really enjoyed meeting him in the flesh:-)

The panel in question, it was the galley that didn't work

And then out for Mexican food.  Maybe not SW worthy, but pretty darn good.

We had to move sites as a big RV show was taking over the area we were staying in at the park, so we moved up the hill to an overlook site.  This park is very interesting as it is built in 3 separate areas, a bottom, halfway up, and all the way up the hill, the views and the prices get better and higher as you go up:-)  We moved halfway up to a very nice site.

Moving sites turned into bit of a challenge as they had over 59 people exiting that morning, and we had to delay and mix in there somewhere.  

As you can imagine there are interesting projects, fun projects, but some are neither, but necessary.  Replacing the dump valves is one of the latter, but they were starting to seep a bit so it was time, and like all projects there has to be a bit of a snag no matter how careful you are.  It's a little messy, as nothing is keeping the liquids in either tank while doing it, but before you're too grossed out, I rinsed and rinsed the tanks, and then tipped the coach over away from the valves to keep it as dry and clean as possible.

The old valves

The new valves and tools

All in

If you've never done this job it is a bit challenging, you need 5 hands.  There is a rubber gasket on both sides of each valve, they have to be aligned perfectly while sliding it into position all the while holding the pipes to spread the opening just wide enough.  I use a lot of silicone grease to help hold the gaskets in place and to lube the gate valve blades, and it usually works okay.  So, of course, with the diesel mechanic, Jan's help we got it all in and tight.  Then you test it with a lot of fresh water and.................go look to see how you did.  We got 50%:-(   The black worked perfectly, but the gray side was just pouring out as if we hadn't even installed a valve!  If you have to pick one or the other this was the desirable option.  Back out, more grease, careful alignment and we got it.  Job done.

So Monday came and we still had 2 items, Jan was supposed to get her hearing aids first thing in the morning, halfway there she gets a call that they never arrived!!  I'll come back to this in a minute, and I had to go and get a root canal.  We headed down south, had a nice lunch then off to the endodontist.  Jan ran some errands while I was taken care of.  We had to drive right past the hearing aid people so on the way back we stopped in to see what was what.  Seemed the hearing aids were sitting in the Fedex distribution facility 60 miles away and hadn't been put on the truck.  No excuses, no real resolution.  I can't tell you how frustrating this is.  We got ourselves calmed down and went back to a gorgeous night for a drink and a cigar and pondered a few solutions to this problem, biggest issue is after Florida we are not coming back here again.

Well the stars finally aligned at 4pm our last day.  Jan got a call from the store that her hearing aids had just arrived so she is now on her way to pick them up.  Now we can work on heading through Atlanta tomorrow on our way back south.